ez trigger step 1 locate a convenient position for the ez trigger away from any high heat source such as the exhaust. mount the ez trigger using the supplied screw or equivalent. step 2 leave all existing wiring in place on the stock coil, except route the coil wire to the coil tower on the new ez trigger instead of the distributor. step 3 connect the trigger wire for your mallory hyfire ignition or other aftermarket ignition to the ?+ ? terminal on the ez trigger. form 1612 05/04 step 4 connect the ???terminal to ground. step 5 connect the balance of the ignition wiring as called out in the ignition s instructions. install your second coil as instructed and route it s coil wire to the distributor. step 6 recheck all connections before starting the engine. installation instructions www.mrgasket.com 1 mallory is a division of the mr. gasket performance group 10601 memphis ave. #12, cleveland, oh 44144 216.688.8300 fax 216.688.8306 form 1612 05/04 made in u.s.a. printed in u.s.a. ez trigger allows the stock coil to send all necessary information to the vehicle? ecu.
|